Recorded Announcements
3.Press 
1 
and record after the tone. Hang up, press 
switchhook when finished.
Drop 
, or press the
4.Dial the extension number of the announcement you just recorded.
5.Listen to the recording. If you need to
6.If the message is satisfactory, hang up and repeat Steps 1 through 3 to record the rest of the messages.
The integrated announcements circuit pack has the following recording time limit based on the sampling rate used:
■8 minutes, 32 seconds at 16 KHz
■4 minutes, 16 seconds at 32 KHz
■2 minutes, 8 seconds at 64 KHz.
For the speech synthesizer circuit pack (TN725B), do the following:
1.At a voice terminal, dial the Verify Wakeup Announcements feature access code _____.
2.Dial 1 or 2.
■Listen to the announcement. There may be a short delay before you hear the announcement.
3.If the wakeup announcement is absent, distorted, inaudible, or defective in any way, follow local procedures to correct the problem.
Administration
change feature-access-codes
■Use this form to add the Announcement and Verify Wakeup Announce- ment feature access codes.
84Issue 1 April 1997
