CiM-550 IP Enabled Satellite Modem

Rev. 2

SNMP interface

CD/CIM550.IOM

OID

Description

 

 

 

cim550EdmacAddress

The EDMAC slave address will set the range of

 

addresses of distant-end units (modems and

 

transceivers) which this unit will forward messages for.

 

Only values that are integer multiples of ten are

 

permitted. Setting the EDMAC slave address to 0

 

disables this function. Valid slave addresses are

 

between 0 and 9999.

cim550UnitTestMode

Unit test mode. Can be set to:

 

 

 

 

 

 

 

0

Normal

 

 

 

 

 

 

 

 

 

1

IF Loop Back

 

 

 

 

 

 

 

 

 

2

Digital Loop Back

 

 

 

 

 

 

 

 

 

3

IO Loop Back

 

 

 

 

 

 

 

 

 

4

Tx CW

 

 

 

 

 

 

 

 

 

5

Tx Alternating Pattern

 

cim550RecenterBuffer

 

 

 

 

 

Command to force the modem to re-center the receive

 

buffer. A value of 1 (yes) is used to issue the operation.

cim550ForceRedundentSwitch

Command to force the modem into STANDBY mode if it

 

is in a redundant pair. A value of 1 (yes) is used to issue

 

the operation.

 

 

 

cim550UnitAlarmMask

Alarm mask conditions, in the form “abcde”, where: a =

 

mask Tx AIS alarm, b = mask Rx AGC alarm c = mask

 

buffer alarms, d = mask Rx AIS alarm e = mask Eb/No

 

alarm Setting any of these bytes to 0 unmasks alarm,

 

setting to 1 masks them. Valid values are between 0 and

 

11111.

 

 

 

 

cim550UnitConfigStore

Forces the unit to store the current modem configuration

 

in a configuration memory location defined by values 0

 

to 9.

 

 

 

cim550UnitConfigLoad

Forces the unit to retrieve the configuration memory

 

location defined by values 0 to 9 and to re-program the

 

unit with that stored configuration.

cim550OduCommEnable

Enables or disables communication, via an FSK serial

 

link, with a Comtech Transceiver (Outdoor unit). Can be

 

set to:

 

 

 

 

 

0

Disable

 

 

 

 

 

 

 

 

1

Enable

 

 

 

 

 

 

 

 

251