CiM-550 IP Enabled Satellite Modem

Rev. 2

CiM IP Module Checkout & Fault Isolation

CD/CIM550.IOM

14.2.8CIM 2 CONFIGURATION

Disconnect RJ-11 end of the console cable from CiM 1 and connect it to CiM 2.

14.2.8.1SETTING IP ADDRESS(ES)

Step Procedure

1 From the Main Menu select Network Configuration sub-menu.

2 Set Ethernet IP Address to 172.17.10.10.

3 Set Subnet Prefix Length to 24.

4 Set HDLC IP Address to 10.1.1.2.

5 Set RX – Enable/Disable and TX – Enable/Disable to Enable.

6 From Receive HDLC Channel Address menu set HDLC Addr 1 to 1 (0x0001)

The other parameters can be left to their factory default settings. At this point you should be able to ping CiM 2 from PC 2:

7ping 172.17.10.10

8ping 10.1.1.2

14.2.8.2ROUTE TABLE

Step Procedure

1From Transmitter Configuration, sub-menu select Route Table sub-menu.

2Enter 1 to configure the first route

3Enter a suitable name

4Set IP Address to 172.16.10.0

5Set Number of Subnet Bits to 24

6Enter the next hop IP address which is CiM 1’s HDLC IP Address, 10.1.1.1

14.2.8.3SAVE CONFIGURATION

Save parameters to permanent storage.

14.2.9VERIFICATION

At this point the basic configuration is over and you should be able to:

Ping PC 1 from PC 2 and vice versa Ping CiM 2 from PC 1 and vice versa Pass any other data between the 2 PCs

If Pings are not successful, refer to section 14.3, Troubleshooting IP Module.

424