WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
•Ignore Broadcast Probe Request. When a client sends a broadcast probe request frame to search for all available SSIDs, this option controls whether or not the system responds for this SSID. When enabled, no response is sent and clients must know the SSID in order to associate to the SSID. When disabled, a probe response frame is sent for this SSID.
This setting can also be configured on a
•DTIM Period. Specifies the interval between the sending of Delivery Traffic Indication Messages (DTIMs) in the beacon. This is the maximum number of beacon cycles before unacknowledged network broadcasts are flushed. When using wireless clients that employ power management features to sleep, the client must revive at least once during the DTIM period to receive broadcasts. The default is 2.
This setting can also be configured on a
•Mixed
•PSK
•WPA/2
If you select PSK
Configure AP Information
Use the General configuration in the Advanced WLAN pages to configure AP logging and debugging, Simple Network Management Protocol (SNMP) system information and trap receivers, and other information.
•To configure information that applies to all APs in the network, navigate to the Configuration > Advanced > WLAN > Network > General page (Figure
To configure information that applies to APs in a specific location in the network:
1.Navigate to the Configuration > Advanced > WLAN > Advanced page.
2.Click Add to add a new location.
3.Enter a location ID in the format building.floor.plan, where each value is an integer.
4.Click Add.
5.Select the General tab.
Configuring WLANS |
