WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
Enabling AP Learning
AP learning allows the system to classify all newly discovered APs as valid APs. By default, AP learning is not enabled and all newly discovered APs are classified as interfering APs. You can enable or disable AP learning from the browser interface.
Note: Enabling AP learning is useful when you install the WFS709TP in an environment 
with an existing
detected and classified as valid. Then disable AP learning and reclassify any unknown APs as interfering.
To enable or disable AP learning:
1.Navigate to the Configuration > Advanced > Security > Rogue AP page on the master WFS709TP (Figure
Figure
2.Enable or disable AP learning.
•To enable AP learning, select the option “Mark All New Access Points as Valid Access Points”
•To disable AP learning, deselect this option.
3.Click Apply.
Classifying APs
If AP learning is enabled, every newly discovered AP is classified as a valid AP. If AP learning is disabled, every newly discovered AP is classified as an interfering AP. You can also manually classify individual APs. For example, if you know about an interfering AP, you can manually reclassify it as a known interfering AP. You can manually classify an AP into one of the following categories:
Configuring Wireless Intrusion Protection |
