NETGEAR WFS709TP-100NAS manual Configuration Pages Basic, Wlan

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual

Table 1-3describes the Basic Configuration pages in the browser interface.

Table 1-3. Configuration Pages (Basic)

Page	Description
WLAN	These pages allow you to configure an SSID and related WLAN options.
Security	These pages allow you to configure the security Profile for Rogue AP detection.
Network	These pages allow you to configure ports, VLANs, IP interfaces, and DHCP-
	related information.
Management	These pages allow you to configure the system clock, SNMP-related
	information, and management access.
Access Point Installation	This page allows you to discover and configure Light Access Points connected
Wizard	to the Switch.

The following buttons are available on both the Basic and Advanced Configuration pages:

•Apply. Accepts all configuration changes made on the current page.

•Save Configuration (appears in top right corner of the browser interface when the Configuration tool is selected). Saves all applied configuration changes made during the current configuration session. Saved settings are retained when the WFS709TP is rebooted or powered off while unsaved configuration changes are lost.

•Clear. Resets options on current page to the last-applied or saved settings.

•Add. Adds a new item to the current page. Typically a set of relevant configuration fields for the item to be added is displayed.

•Edit. Allows you to edit the configuration of the selected item.

•Delete. Removes the selected item from the page configuration.

Note: By default, clicking Apply does not save the configuration. Once you finish configuring the switch, always remember to click Save Configuration.

Overview of the WFS709TP 1-19

v1.0, June 2007