Changing the Protocol to Http

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual

Table 8-1.Captive Portal Authentication Browser Interface Page Options (continued)

Parameter	Description	Default

Login Page Location	The page that appears for the user logon. This can be set to	/auth
	any URL.	/index.html
Logon Wait Interval	Time range, in seconds, the user will have to wait for the logon	5–10 seconds
	page to pop up if the CPU load is high. Works in conjunction
	with the CPU Utilization Threshold.

CPU Utilization	If CPU utilization is above this percentage, the Logon Wait	60%
Threshold	Interval is applied.

Match ESSID List (Base	Specifies the ESSIDs on which the Captive Portal is enabled.
operating system only)

Proxy Host: Port (Base	Specifies the IP address of the proxy host and port used for
operating system only)	HTTP or HTTPS access.

Wired-to-Wireless	Allows authenticated user to remain authenticated when
Roaming ESSID List	roaming between wired and wireless networks.

Select the options desired, then click Apply to apply the configuration.

Configuring the AAA Server for Captive Portal

The Captive Portal Authentication page allows you to choose the authentication servers to be used for user authentication:

1.From the Choose an Authentication Server a pull-down menu, to select the authentication server that will be the primary server.

2.Click Add for the selection to be applied.

3.To add additional authentication servers as backup servers, repeat steps 1 and 2.

Servers are listed in order of descending priority. The first entry is always the primary server

4.(Optional) To change the list order, use the up or down arrows to move an entry higher or lower in the list.

5.Click Apply.

By default, HTTPS is used on redirection to the Captive Portal page. If you need to use HTTP instead, do the following:

Configuring the Captive Portal

8-5