NETGEAR WFS709TP-100NAS WFS709TP Traps, WFS709TP Snmp Traps, Trap Description Priority Level

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual

SNMP Traps

WFS709TP Traps

Table 13-5lists the key traps generated by the WFS709TP.

Table 13-5. WFS709TP SNMP Traps

Trap	Description	Priority Level
WFS709TP IP changed	The WFS709TP IP has been changed. The WFS709TP IP is	Critical
	either the loopback IP address or the IP address of the VLAN
	1 interface (if no loopback IP address is configured).
WFS709TP role changed	The WFS709TP has transitioned from being a master	Critical
	WFS709TP to a local WFS709TP, or vice versa.
User entry created/	Each of these traps is triggered by an event related to a user	Medium.
deleted/authenticated/	event. The event can be a new user entry being created in the
de-authenticated/	user table, deletion of a user entry, a user getting
authentication failed	authenticated successfully, a user getting de-authenticated, or
	a failed authentication attempt.This is a local event to the
	WFS709TP where the user is visible, and each of these traps
	will be generated by the WFS709TP on which the user event
	occurs.
Authentication server	A request to a authentication server did not receive a	High.
request timed out	response from the server within a specified amount of time,
	and therefore the request timed out. This usually indicates a
	connectivity problem from the WFS709TP to the
	authentication server or some other problem related to the
	authentication server.
Authentication server	An authentication server has been taken out of service. This	High
timed out	trap is almost always same as AuthServerReqTimedOut
	except when there is only one authentication server, in which
	case the server will never be taken out of service.
Authentication server up	An authentication server that was previously not responding	Low.
	has started responding to authentication requests. This trap
	will be triggered by a user event that causes the WFS709TP
	to send an authentication request to the authentication server.
Authentication user table	The authentication user table has reached its limit of the	Critical.
full	number of user entries it can hold. This event is local to the
	WFS709TP that generates the traps. The maximum number
	of user entries that can be present at the same time in the
	user table is 4096.
Authentication Bandwidth	The maximum number of configured bandwidth contracts on	High
contracts table full	the WFS709TP has been exceeded. The threshold is 4096.
Configuring Management Utilities		13-9

v1.0, June 2007