NETGEAR WFS709TP-100NAS manual Configuring Management Utilities 13-7

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual

Table 13-4. SNMPv3 Access Point User Details (continued)

Field	Description	Expected/Recommended Values
Privacy protocol	An indication of whether messages	This takes the value DES (CBC-DES
	sent on behalf of this user can be	Symmetric Encryption Protocol).
	protected from disclosure, and if so, the
	type of privacy protocol that is used.
Privacy protocol	If messages sent on behalf of this user	String password for DES.
password	can be encrypted/decrypted, the
	(private) privacy key for use with the
	privacy protocol.

All the parameters listed in Table 13-4can also be configured for a subset of all the access points in the network by using the location code of the access points in the building.floor.location format. The administrator can use 0 as the wild card value for any of the fields in this format. As an example, all APs in building 10 can be represented by the location code 10.0.0. To configure the SNMP parameters for a set of APs, follow these steps:

1.Navigate to the Configuration > Advanced > WLAN > Advanced page on the browser interface of the master WFS709TP.

2.Determine if the required AP set already exists.

•If the required set does not exist, click Add to add the set of APs represented by a location code, using 0 as the wild card value when required.(Figure 13-3).

•If the set already exists, click Edit for the chosen set and proceed to step 4 to configure the SNMP parameters for the chosen set.

Figure 13-3

Configuring Management Utilities 13-7

v1.0, June 2007