NETGEAR WFS709TP-100NAS manual Chapter Configuring Network Parameters, Configuring VLANs

Chapter 3

Configuring Network Parameters

This chapter describes basic network configuration on the WFS709TP ProSafe Smart Wireless Switch. It includes the following topics:

•“Configuring VLANs” on page 3-1

•“Configuring Static Routes” on page 3-5

•“Configuring the Loopback IP Address” on page 3-6

Configuring VLANs

The WFS709TP ProSafe Smart Wireless Switch operates as a Layer 2 switch that uses a VLAN as a broadcast domain. As a Layer 2 switch, the WFS709TP requires an external router to route traffic between VLANs. The WFS709TP can also operate as a Layer 3 switch that can route traffic between VLANs defined on the switch.

You can configure one or more physical ports on the WFS709TP to be members of a VLAN. Additionally, each wireless client association constitutes a connection to a virtual port on the switch, with membership in a specified VLAN. You can place all authenticated wireless users into a single VLAN or into different VLANs, depending upon your network. VLANs can exist only inside the WFS709TP; you must use 802.1q VLAN tagging to extend them outside the switch.

You can optionally configure an IP address and netmask for a VLAN on the WFS709TP. The IP address is up when at least one physical port in the VLAN is up. The VLAN IP address can be used as a gateway by external devices; packets directed to a VLAN IP address that are not destined for the switch are forwarded according to the WFS709TP’s IP routing table.

Creating a VLAN

To create or edit a VLAN:

1.Navigate to the Configuration > Basic > Network > VLAN page on the browser interface.

2.Click Add to create a new VLAN. (To edit an existing VLAN, click Edit for the VLAN entry.)

3-1

v1.0, June 2007