NETGEAR WFS709TP-100NAS manual AM Modeling Parameters, Users, Rates

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual

Users

Note: The Users text boxes are active only when the Capacity model is selected.

•Enter the number of users you expect to have on your WLAN in the Users text box.

•Enter the number of users per AP you expect in the Users/AP text box.

The numbers entered in the these two text boxes must be non-zero integers between 1 and 255, inclusive.

Rates

Note: The Rate pull-down menus are active only when the Coverage or Capacity design models are selected.

Select the desired data rates from the pull-down menus for 802.11b/g and 802.11a.

High data transmission rates require an increased number of APs to be placed in your building. Carefully evaluate the data rate needs of your users.

AM Modeling Parameters Page

The AM Modeling Parameters page (Figure 4-6) allows you to specify the information necessary for RF Plan to determine the appropriate placement of your air monitors.

Figure 4-6

Controls on this page allow you to select the following functions, which are described in more detail in this section:

RF Plan 4-9

v1.0, June 2007