NETGEAR WFS709TP-100NAS manual AP Modeling Parameters

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual

When width and length are specified, RF Plan creates a rectangular area in the Planning feature pages that represent the overall area covered by the building. You need to import an appropriate background image (“Floor Editor Dialog Box” on page 4-12) to aid you in defining areas that don’t require coverage or areas in which you do not wish to deploy APs and AMs (“Area Editor Dialog Box” on page 4-13).

•Inter-Floor Height. This is the distance between floor surfaces in the building.

Note: The inter-floor height is not the distance from floor to ceiling. Some buildings have a large space between the interior ceilings and the floor above.

The valid range for this field is any integer from 1 to a value corresponding to 1x1012.

•Floors. Enter the number of floors in your building. The valid range for this field is any integer from 1 to a value corresponding to 1x1012.

•Unit. Specify the unit of measurement for the dimensions you specified on the page. The choices are feet and meters.

AP Modeling Parameters Page

The AP Modeling Parameters page (Figure 4-5) allows you to specify the information necessary for RF Plan to determine the appropriate placement of your APs.

Figure 4-5

Controls on this page allow you to select or control the following functions, which are described in further detail in this section:

•Radio Type. Use this pull-down menu to specify the radio type.

•AP Type. Use this drop-down box to select the AP model.

•Overlap Factor. Use this field and pull-down to specify an AP coverage overlap factor.

RF Plan 4-7

v1.0, June 2007