NETGEAR WFS709TP-100NAS manual Configuring IRM

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual

•The AP response time to noise is quick and reliable, even to non-802.11 noise, especially when client traffic starts generating errors due to the noise.

•Non-802.11 noise detection is disabled by default and must be explicitly enabled.

•The IRM algorithm is based on what the AP hears, which means that the system can compensate for scenarios like broken antennas or blocked signal coverage on neighboring APs.

•Since channel decisions are based on the information the AP receives from the RF environment, interference due to third-party APs is taken into account.

Configuring IRM

1.Enable IRM for each AP and for the 802.11b/g radio.

•To enable IRM under the global setting, navigate to Configuration > Advanced > WLAN > Radio.

•To enable IRM for individual APs, navigate to Configuration > Advanced > WLAN > Advanced.

•To enable IRM on the 802.11b/g radio, navigate to the Configuration > Advanced > WLAN > Radio page (Figure 5-9).

Figure 5-9

5-20 Configuring WLANS

v1.0, June 2007