NETGEAR WFS709TP-100NAS manual Limiting the Number of Active Voice Calls

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual

Limiting the Number of Active Voice Calls

You can limit the number of active voice calls allowed on a radio. This feature is disabled by default. When the disconnect extra call feature is enabled, the system monitors the number of active voice calls, and if the defined threshold is reached, any new calls are disconnected. The AP denies association requests from a device that is on call.

You enable this feature in the WLAN configuration. You also need to enable call admission control, which is disabled by default. You can also configure the number of simultaneous calls that a radio can handle on a per-protocol basis.

To limit the number of active voice calls:

1.Navigate to the Configuration > Advanced > WLAN > Advanced page.

2.Click Add to add a new location.

3.Enter a location ID in the format building.floor.plan, where each value is an integer.

4.Click Add.

5.Select the General tab.

6.Select VoIP CAC Disconnect Extra Call.

7.Click Apply.

8.Select the 802.11b/g or 802.11a tab to configure radio settings.

9.Scroll to the bottom of the page to display VoIP parameters.

10.Select VoIP Call Admission Control.

11.Configure the Call Capacity for the VoIP protocol if needed.

12.Click Apply.

Configuring WFS709TP for Voice 14-3

v1.0, June 2007