NETGEAR WFS709TP-100NAS manual V1.0, June

WFS709TP ProSafe Smart Wireless Switch Software Administration Manual

Figure 2-5

c.In the Configuration UI, click the Configuration tab>Advanced option>DHCP Server, then enter the information to configure the DHCP server. (Figure 2-6)

Figure 2-6

Connect the access points directly to the switch using an Ethernet cable to one of the Fast Ethernet Ports on the switch (this does not need to be the final installation location for the access points). Allow up to 10 minutes for the switch to locate and download firmware to the access point(s).

3.In the web browser of your PC, navigate to the Access Point Installation Wizard:

a.Verify that the access point(s) are detected by the system by clicking the Configuration tab > Basic option > Access Point Installation Wizard > Monitoring. Unconfigured access points will be listed as unprovisioned.

b.Follow the prompts of the Wizard to complete configuration of the switch for all access points.

4.Refer to the documentation included with the access points to complete their installation.

Deploying a Basic WFS709TP System 2-9

v1.0, June 2007