Section II - Advanced Management Features

The setting of certain variables causes an immediate firmware reset. These variables are listed in the private MIB under cmdReset.

Note: If you attempt a reset while a job is printing, the job may not print successfully.

Certain variables are critical, that is, they change a fundamental operating parameter of the OkiLAN

6010e. These variables are saved by the OkiLAN 6010e but are not actually used until it is power cycled or is reset. When any one of these variables is changed the variable genConfigDirty is automatically set to yes by the print server. This signifies a reset is required for all configuration changes to be made active. We recom- mend checking the genConfigDirty variable after using a MIB browser to make any configuration changes to the OkiLAN 6010e. If genConfigDirty is set to yes, then the cmdReset variable should also be set to yes. This will cause the OkiLAN 6010e to reset, make all con- figuration changes active on the OkiLAN 6010e and set both the cmdReset and genConfigDirty variables to no. These critical variables are listed in the private MIB under genConfigDirty.

Traps

Traps are unsolicited information from the SNMP agent. The OkiLAN 6010e uses a ColdStart trap to inform the manager it has been powered on or reset. An authentication failure trap is sent when the OkiLAN 6010e receives an SNMP trap GET or SET request with an incorrect community name.

II - 6

OKI OkiLAN 6010e User’s Guide

Page 28
Image 28
Oki 6010E manual Traps