Pioneer 12 technical manual 567, Plasma Display Section

Controls and Connectors

Connection Panel

When installing PDA-5003

S-VIDEO	INPUT3	VIDEO	INPUT4	INPUT 3/4	AUDIO			ANALOG RGB		INPUT5	AUDIO
		IN	OUT	R	L	G(ON SYNC)	B	R	HD (H/V SYNC) VD	R	L

~	! @		#		$			%
When installing PDA-5004
S-VIDEO	INPUT3	AUDIO	VIDEO	INPUT4	AUDIO	COMPONENT	INPUT5	AUDIO
						VIDEO

	R L	IN OUT	R	L	Y Pb/Cb	Pr/Cr	R	L
^	&	* (	)		_			+

IN	OUT			OUTPUT	INPUT1 INPUT2
COMBINATION			RS-232C	AUDIO	AUDIO AUDIO
1	2	3	4	567

- =

		INPUT1		INPUT2
ANALOG RGB OUT	ANALOG RGB IN		DIGITAL RGB
(D-Sub)		(D-Sub)	(DVI-D)

8 9 0

Plasma Display Section

1 COMBINATION IN/OUT

Never connect any component to these connectors without first consulting your Pioneer installation technician.

These connectors are used for Plasma Display setup adjustments.

2 SPEAKER (R) terminal

For connection of an external right speaker. Connect a speaker that has an impedance of 6 Ω to

16Ω.

3 SPEAKER (L) terminal

For connection of an external left speaker. Connect a speaker that has an impedance of 6 Ω to 16 Ω.

4RS-232C

Never connect any component to this connector without first consulting your Pioneer installation technician.

This connector is used for Plasma Display setup adjustments.

5AUDIO (OUTPUT) (Stereo mini jack)

Use to output the audio of the selected source component connected to this unit to an AV amplifier or similar component.

Note: No sound is produced from the AUDIO (OUTPUT) jack when the MAIN POWER switch is set to OFF or when set to Standby.

6 AUDIO (INPUT1) (Stereo mini jack)

Use to obtain sound when INPUT1 is selected. Connect the audio output jack of components connected to INPUT1 to this unit.

7 AUDIO (INPUT2) (Stereo mini jack)

Use to obtain sound when INPUT2 is selected. Connect the audio output jack of components connected to INPUT2 to this unit.

8 ANALOG RGB OUT (INPUT1) (mini D-sub 15 pin)

Use the ANALOG RGB OUT (INPUT1) terminal to output the video signal to an external monitor or other component.

Note: The video signal is not output from the ANALOG RGB OUT (INPUT1) terminal when the panel's main power is OFF or the panel is in Standby.

9 ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)

For connection of a personal computer (PC) or similar component. Confirm that the connection made corresponds to the signal output from the connected component.

0 DIGITAL RGB (INPUT2) (DVI-D jack)

Use this input to connect to a computer. Connect to an AV component (HDCP supported) equipped with DVI output connector.

-AC IN

Use to connect the supplied power cord to an AC outlet.

=MAIN POWER switch

Use to switch the main power of the unit on and

off.11