Pioneer 12 technical manual Installation on the Plasma Display, Installation procedure

Speaker System: PDP-S55-LR

4.6.3 Installation on the Plasma Display

1) Installation procedure

Install the speaker system according to the steps 1 through 5.

Note:

The speakers are divided into a right (R) and left (L) speaker. When attaching the speakers, be sure to check to labels (R/L) located on the rear of the speakers.

1 Remove the seals from the cushions and then attach the cushions to the sides of the speakers in the locations indicated in the diagram below.

Cushions

3 Loosely screwing the screws (M5) into place on the top attachment pieces (two locations).

Note:

To install the Plasma Display on a wall, first attach the attachment pieces to the Plasma Display then install it on the wall. After installing the Plasma Display on the wall, it may be impossible to tighten the screws on the attachment pieces.

2Attaching the attachment pieces to the locations shown in the drawing of the Plasma Display with screws (M5) (eight locations).

Check the marks on the attachment pieces (TL, TR, BL, BR) and the Plasma Display attachment locations.

4 Attaching the screws (M5) that have been loosely screwed into place on the hooks on top of the speakers. Loosely screw the screws (M5) into place with the screw holes on the attachment pieces on the bottom aligned with the holes in the hooks on the bottom of the speakers.

74