Pioneer 12 Hardware assembly and Plasma Display attachment, Attaching the metal fittings

Wall Mount Unit: PDK-WM03

4.5.3 Hardware assembly and Plasma Display attachment

1) Attaching the metal fittings

The display comes with left side hardware and right side hardware. Do the installation so that the two eyebolts are both on the inside.

É” 9

Eyebolt

Right

1 Align the screw holes (ø9) at the positions on the drawing above and below the display metal fittings (one each on the left and right side) with the screw holes (M8) on the back surface of the Plasma Display to anchor the two attached M8 screws.

Note

When using the optional stand PDK-TS26, you can attach the display metal fitting with the stand installed. When doing this, before attaching the display metal fitting, remove the four M6 screws that anchor the display to the stand. Make sure that when you lift the Plasma Display, you do not also lift the stand with it. If the stand is displaced, it may cause injuries or be damaged.

Left

2) Installing the hung on wall unit on the wall

Fix it in position with off-the-shelf anchors or with six M8 screws.

	Unit: mm (inch)
			950 (37-13/32)
494.5(19-15/32)	400(15-3/4)	187(7-3/8)	Center of	591(23-9/32)
			the display
			850 (33-15/32)

Note

Be sure to attach the anchors or screws to locations of wall beams.

70