Pioneer 12 Setting the Power on Delay, Turns on the power approximately every, Second, Screen =

Integrator Mode

7 Setting AUTO ID	Screen 9
When ‘ON‘ is set, the ID for each of the multiple displays
linked by the remote control cable is set automatically.		V I D E O WA L L
9 Place the cursor on ‘AUTO ID’ then press the [SET] button.		D I V I DE R	: 2 5
		P O S I T I ON
		T Y P E	: N O R M A L
		AU TO I D
		P . O N D E L AY	: O F F
		A B L L I N K	: O F F
		R E T U R N

SET

ENTER

MENU

EXIT

0Press the [2/3] buttons to change the settings.

-Press the [SET] button. [Setting the AUTO ID]

ON ....... The AUTO ID function operates

In the case of the four screen configuration, shown below, Display1 = ID1 and Display 4 = ID4.

Auto ID is only available for four screen/nine screen Video

Walls.				COMBINATION
COMBINATION		No.1	No.2	OUT		No.1	No.2	COMBINATION
IN		No.4	No.3	COMBINATION		No.4	No.3	OUT
				IN
	Display 1				Display 2
				COMBINATION
				OUT
COMBINATION		No.1	No.2			No.1	No.2	COMBINATION
OUT		No.4	No.3			No.4	No.3
				COMBINATION				IN
	Display 3			IN
					Display 4

Screen 0, -

		AU TO	I D
AU TO	I D		:	O N
1	2	1	2	3
4	3	8	9	4
		7	6	5
SET SET				MENU EXIT

OFF ..... The AUTO ID function does not operate.

Note

To execute AUTO ID, be sure to set ID NO. SET in OPTION to a setting other than ALL.

7Setting the POWER ON DELAY

This option sets the power ON timing for the panels that make up a video wall to avoid a power surge.

=Place the cursor on ‘P.ON DELAY’ and press the [2/3] buttons to change the settings.

[Setting the POWER ON DELAY]

(When one, four, and nine screen Video Walls)

	3	ON
		OFF 2
ON	Turns on the power approximately every
	second.
OFF	When the power is turned on, the power of all
	the displays turns on at the same time.

Screen =

V I D E O WA L L

D I V I D E R	: O F F
P O S I T I ON	: N O R M A L
T Y P E
AU TO I D	: O F F
P . O N D E L AY
A B L L I N K	: O F F
R E T U R N
SET	MENU EXIT

Note

•This function is effective when the AUTO ID setting is ‘ON’. Set the AUTO ID in advance.

•After setting this function, turning on the power to the first display causes the other units to turn on in succession.

•From the second display, it is not possible to turn on the power using the remote control or control panel. To

158forcibly turn a panel on, press and hold the remote control’s STANDBY/ON button for three or more seconds.