Pioneer 12 technical manual INPUT1

Video Card: PDA-5003/PDA-5004

When connecting to COMPONENT VIDEO (INPUT5)

[Connections for PDA-5004]

COMPONENT	INPUT5
VIDEO

Y Pb/Cb Pr/Cr

When connecting to ANALOG RGB (INPUT5)

[Connections for PDA-5003]

		ANALOG RGB	INPUT5
G(ON SYNC)	B	R	HD (H/V SYNC) VD

On-screen setup is necessary after connection.

Connection of composite SYNC analog RGB

source

Make composite SYNC connections for a personal computer with output that has the vertical synchronization signal layered on top of the horizontal synchronization signal.

When connecting to ANALOG RGB IN (INPUT1)

		INPUT1
ANALOG RGB OUT	ANALOG RGB IN
(D-Sub)		(D-Sub)

On-screen setup is necessary after connection.

When using INPUT5, set the impedance selector switch to match the output impedance of the connected computer’s synchronization signal.

When the output impedance of the sync signal is below 75 Ω remove the video card and set the impedance selector switch to 75 Ω.

On-screen setup is necessary after connection.

Notes

÷When making composite SYNC connections, do not connect anything to the VD jack. If connected to, the picture may not be displayed properly.

÷Some types of computer devices manufactured by Apple Computer, Inc. are equipped with both G ON SYNC and composite SYNC outputs. This type of component should be connected using the G ON SYNC connection.

57