Pioneer 12 technical manual Viewed from Above Viewed from the Right Side

Special Installation (Place product upright and flush, embedded in the wall)

3.4.7 Place product upright and flush into wall (embedding in the wall)

Carefully read the following instructions before trying to embed the unit in a wall. Observe all the limitations specified below.

Be sure to mount the unit so that twisting, bending, or other deformation of the unit does not exceed 4 mm.

(1)Embedding in walls with space provided behind the unit (with no obstructions within a distance of 300 mm from the back surface of the unit)

A

A

X (Front of the unit)

A

Y (Rear of the unit)

<Viewed from Above>

A

<Viewed from the Right Side>

✩Operating Temperature Restrictions (*1)

Temperature in space X and Y

A: 0 mm to 370 mm 0 °C to 40 °C

*1 For this installation, set the ‘FAN CONTROL’ to ‘MAX’ as shown in “5.4.3 Adjustment and Setting in the Integrator Mode 14) Cooling Fan Control Setting” (pg. 163).

36