Pioneer 12 technical manual Speaker System PDP-S55-LR

Speaker System: PDP-S55-LR

5Tighten the screws just inserted firmly into place (four locations).

¶Tighten the screws while pushing the speakers lightly against the Plasma Display. Check to be sure that all four screws have been screwed firmly into place.

¶If there is a large gap between the Plasma Display and the speakers, adjust them after slightly loosening the screws that were tightened in step 2. After adjustment, re-tighten the screws.

¶To install the Plasma Display on a wall, it is recommended that you first remove the speaker units, then after the Plasma Display has been installed on the wall, re-attach the speaker units to the Plasma Display.

2) Connect the cords

(Turn off the power of all connected units before connecting the cords.)

Use the provided speaker cords to connect the R/L speaker jacks of the monitor to the speaker jacks of the speakers.

Once the cords have been connected, pull on the cords lightly to make sure that they have been connected firmly to the speaker jacks. An improper connection might re- sult in the sound being interrupted or the appearance of noise in the output sound.

Cord clampers Remove the seal from the rear of the cord clampers, attach the clampers in the desired position, and clamp the cords into place.

Warning

¶Never hold the speakers when speakers are attached to the monitor to move the monitor. Doing so might result in the monitor falling, and this in turn might result in bodily injury.

¶Firmly tighten the screws. The speakers may fall causing injuries.

Note that the speaker cords have positive and negative ends, and that you should be sure to insert them correctly.

Black

Red

Press the button of the speaker jack and keep it pressed down as you insert the wire of the speaker cord and then release the button.

75