Pioneer 12 technical manual Stand assembling

Table Top Stand: PDK-TS26

4.4.4 Stand assembling

1Remove the cardboard and accessories (screws, operating instructions) from the box.

4Tear off the protective sheets covering the feet from their perforated lines so you can see their attach- ments.

¶View of packaged items

Shock absorbing boxes

Cardboard	¶ Place them so the attachments are towards you.
Shock absorbing
boxes	Attachment
Screws / Securing
brackets	Perforated line
Operating instructions
Bar	Toward you
(Covered with
protective sheets)
Feet
(Covered with protective sheets)

2Remove the bar then remove the shock absorbing boxes from the left and right sides.

5Take the protective sheet off the bar that you removed in step 2, insert the bar aligned with the guide pins of the feet.

If the bar and guide pins on the feet do not match, the feet and bar are in reversed position. Reverse the left and right ends of the bar and align it with the pins again.

Then tighten it with the included stand assembly screws (M4 ⋅ 10 mm).

Guide pins

3Remove the two boxes containing the feet, and set them upside down on the floor.

Caution

Tighten the screws firmly. The stand may fall over causing injuries.

6Pick up the boxes containing the feet, turn them over again, and put them back on the floor. Then take the box out of its stand.

66