Pioneer 12 technical manual DVI Setting, Plug/Play Pc, PC 2 3 Video, LOW 0 to 255 High 16 to 235

[Applicable only when a PDA-5003/PDA-5004 is installed] Menu Mode

10) DVI Setting

Choose the component type (either [PC] or [VIDEO]) that is connected to INPUT2.

Settable condition:	INPUT2
Factory setting:	PLUG/PLAY: PC
	BLACK LEVEL: LOW

1 Select ‘SETUP’.
2 Place the cursor on ‘DVI SET UP’ then press the [SET]	Screen 2
button.
	M E N U		I N P U T 1
	PICTURE S C R E E N	S E T U P	O P T I O N
	P O W E R M G T.	: O F F
	S I G N A L F O R M AT
	D V I S E T U P

SET ENTER

MENU EXIT

3Place the cursor over ‘PLUG/PLAY’ and press the [2/3] button to change the setting.

Each time a [2/3] button is pressed, the setting changes as shown below.

3PC 2 3 VIDEO* 2

*Applicable only when the video card is installed.

4Place the cursor over ‘BLACK LEVEL’ then press the [2/3] button to change the setting.

Each time the [2/3] button is pressed, the setting changes as shown below.

3LOW (0 to 255) 2

3HIGH (16 to 235) 2

Screen 3

	DV I S E T U P
P L U G / P L AY	: P C
B L AC K L E V E L	: L OW
SET SET	MENU EXIT

Screen 4

	DV I S E T U P
P L U G / P L AY	: P C
B L AC K L E V E L	: L OW
SET SET	MENU EXIT

Note

When ‘PLUG/PLAY’ is set to ‘VIDEO’ then ‘BLACK LEVEL’ is set to ‘HIGH’. However, there are devices that can adjust BLACK LEVEL so confirm the setting on the device.

129