Pioneer 12 technical manual Power on Mode Setting, Volume, Last INPUT1 Multi INPUT2

Integrator Mode

20) POWER ON MODE Setting

This function sets the input at the time the power is switched on.

Factory setting: INPUT	LAST
VOLUME	LAST

1 Enter the integrator mode.

(Refer to section 5.4.1, “About the Integrator Mode” (pg. 142).)

2 Select ‘OPTION’.

3 Place the cursor on ‘PWR. ON MODE’ then press the [SET] button.

Screen 3

I N T E G R AT O R		I N P U T 1
PICTURE S C R E E N	S E T U P	O P T I O N
P W R . O N M O D E
S E A M L E S S S W	: O F F
M I R R O R M O D E
M U L T I S C R E E N S E T
R E P E AT T I M E R
F U N C T I O N R E S E T
SET ENTER	MENU	EXIT

4Place the cursor on ‘INPUT’ then use the [2/3] buttons to change the settings.

Each time a [2/3] button is pressed, the setting changes as shown below.

For PC signal input

3 LAST 2	3 INPUT1 2
3 MULTI 2	3 INPUT2 2

For video signal input (Applicable only when a PDA-5003/ PDA-5004 is installed.)

3LAST 2 3 INPUT1 2 3 INPUT2 2 3 INPUT3 2 3 MULTI 2 3 INPUT5 2 3 INPUT4 2

Select ‘MULTI’ then press the [SET] button to change to

two-screen input.

Screen 4

P W R . O N	M O D E
I N P U T	: I N P U T 1
V O L U M E	: 0
R E T U R N	:
SET	MENU EXIT

172