Pioneer 12 technical manual Video Wall Setting, Position Type Normal Auto ID OFF On Delay ABL Link

Integrator Mode

11) VIDEO WALL Setting

Use this feature to configure a four panel to 25-panel video wall.

Note

This setting is adjusted when the screen size is full display.

It is not correctly displayed in other screen sizes. (See pg. 89)

Factory setting: DIVIDER	OFF
POSITION	–
TYPE	NORMAL
AUTO ID	OFF
P.ON DELAY	OFF
ABL LINK	OFF

[Setting Method]

7Setting the ID NO. SET

Refer to “13) Assigning an ID“ (pg. 161)

7Setting the screen divider

1 Enter the integrator mode.

(Refer to section 5.4.1, “About the Integrator Mode” (pg. 142).)

2 Select ‘OPTION’.
3 Place the cursor on ‘VIDEO WALL’ then press the [SET]	Screen 3
button.
		I N T E G R AT O R					I N P U T 1
		P I C T U R E			S C R E E N	S E T U P		O P T I O N
		P R OG R A M T I M E R
		S C R E E N M A S K				: G R E E N
		S I D E	M A S K
		V I D E O		WA L L
		BAU D	R A T E			: 3 8 4 0 0 B P S
		I D N O . S E T				: 0 1 H

SET

ENTER

MENU

EXIT

4 Place the cursor on ‘DIVIDER’.

5 Press the [2/3] buttons then press the [SET] button to change the settings.

Each time the [2/3] buttons are pressed, the setting changes as shown below.

	3OFF 3		31 3		3 2x2 3	3 3x3 3
			3 5x5	3	3 4x4	3
OFF, 1	.....	Screen division is not performed. Set it to ‘1‘
		to set an ABL link without dividing the screen.
2x2		Four panel video wall
3x3		Nine panel video wall
4x4		16-panel video wall
5x5		25-panel video wall

Screen 4, 5

V I D E O WA L L

D I V I D E R	: O F F
P O S I T I ON	: N O R M A L
T Y P E
AU TO I D	: O F F
P . O N D E L AY
A B L L I N K	: O F F
R E T U R N
SET	MENU EXIT

Note

•When 4 to 25 screens have been selected, set POSITION.

•When a problem occurs while programming the video wall settings, externally power down the video wall panels.

156