Pioneer 12 Cooling Fan Control Setting, ‘FAN CONTROL’ setting is common for all inputs Screen

Integrator Mode

14) Cooling Fan Control Setting

A cooling fan is located on the rear surface of the display.

This function switches the method for controlling this fan.

For automatic control according to an internal temperature sensor, Set to ‘AUTO’.

For maximum rpm (AUTO CONTROL: OFF): Set to ‘MAX’.

Note

The ‘MAX’ setting is effective for special installations.

However, since the fan rotation noise increases, the effect on the surrounding area should be taken into consideration. For details, refer to section 3, “Installation Site Requirements” (pg. 15).

Factory setting: AUTO

1 Enter the integrator mode.

(Refer to section 5.4.1, “About the Integrator Mode” (pg. 142).)

2 Select ‘OPTION’.

3Place the cursor on ‘FAN CONTROL’ then press the [SET] button to change the setting.

Each time the [SET] button is pressed, the setting changes as shown below.

3 AUTO 3 MAX

The ‘FAN CONTROL’ setting is common for all inputs.

Screen 3

I N T E G R AT O R				I N P U T 1
PICTURE S C R E E N		S E T U P		O P T I O N
F A N C O N T R O L		: A U T O
O S D	I N D I C ATO R :
F R O N T			O N
C O L O R MOD E		: N O R M A L
P R O U S E
F R C		:	O N
SET CHANGE			MENU	EXIT

163