Pioneer 12 technical manual Repeat Timer Setting, Setting the single screen Repeat Timer

Integrator Mode

24) REPEAT TIMER Setting

When two input modes have been set, they are displayed alternatively. This can be used to set one screen, two screens, or video wall.

Factory setting: REPEAT TIMER	SINGLE
1. WORK TIME	00H10M
INPUT MODE	INPUT1
2. WORK TIME	00H10M
INPUT MODE	INPUT2

1 Enter the integrator mode.

(Refer to section 5.4.1, “About the Integrator Mode” (pg. 142).)

2 Select ‘OPTION’.

3Place the cursor on ‘REPEAT TIMER’ then press the [SET] button.

4Place the cursor on ‘REPEAT TIMER’ then use the [2/3] buttons to change the settings.

Each time a [2/3] button is pressed, the setting changes as shown below.

				3
	3 VIDEO WALL 3		3 MULTI		3 SINGLE 3
VIDEO WALL		It operates REPEAT TIMER during video
		wall.
MULTI		It operates REPEAT TIMER during two
		screen display.
SINGLE		It operates REPEAT TIMER during
		single screen display.

Screen 4

R E P E AT T I M E R

R E P E AT T I M E R			:	S I N G L E
1		W O R K T I M E	: 0 0 H 1 0 M
		I N P U T M O D E	: I N P U T 1
2		W O R K T I M E	: 0 0 H 1 0 M
		I N P U T M O D E	: I N P U T 2
		SET		MENU EXIT
	SET

Each item is set as follows.

Select the item with the [5/∞] buttons and change its setting with the [2/3] buttons.

7Setting the single screen REPEAT TIMER

•WORK TIME .......... It sets the display time in a range from one minute to 24 hours.

•INPUT MODE ........ It sets the signal that is displayed

INPUT1 ⇔ INPUT2

Note

Perform this operation after turning the setting of DIVIDER in “5.4.3 Adjustments and setting in the Integrator Mode: 11) VIDEO WALL Setting (pg. 156)” to OFF.

180