Pioneer 12 technical manual DNR digital noise reduction Setting, OFF High 2 3 Middle 2 3 LOW

Menu Mode [Applicable only when a PDA-5003/PDA-5004 is installed]

3)DNR (digital noise reduction) Setting

The DNR (digital noise reduction) setting can be changed to improve the S/N ratio when a video signal is input. The setting should be performed for each input (INPUT1 to INPUT 5) and each signal.

Settable conditions:	When there is video signal input
Factory setting:	MIDDLE

1 Select ‘SETUP’.

2Place the cursor over ‘DNR’ then press the [SET] button.

Screen 2

M E N U				I N P U T 1
P I C T U R E S C R E E N			S E T U P	O P T I O N
C O L O R T E M P.			: M I D D L E
A U T O P O W E R O F F			: D I S A B L E
D N R			: M I D D L E
M P E G N R			: L O W
C T I			: O N
P U R E C I N E M A			: O F F
C O L O R D E C O D I N G			: R G B
C O L O R S Y S T E M			: A U T O
S I G N A L F O R M AT
	SET	ENTER	MENU EXIT

3Each time a [2/3] button is pressed, the setting changes as shown below.

3OFF 2

3 HIGH 2 3 MIDDLE 2 3 LOW 2

Note

DNR is unavailable during 1080p signal or multi screen display.

Screen 3

D N R	:	M I D D L E
SET SET		MENU EXIT

120