Pioneer 12 technical manual SUB Volume Setting, Audio block diagram concept diagram

Integrator Mode

7)SUB VOLUME Setting

This item is for adjusting the audio input level for each input.

This is useful when adjusting the level between different sources, for example a DVD player and a PC. After muting the audio before hand, enter the integrator mode and perform the adjustment.

1Enter the integrator mode.

(Refer to section 5.4.1, “About the Integrator Mode” (pg. 142).)

2Select ‘SETUP’.

3 Place the cursor on ‘SUB VOLUME’ then press the [SET]	Screen 3
button.		I N T E G R AT O R							I N P U T 1
	P I C T U R E			S C R E E N		S E T U P				O P T I O N
	B R T. E N H A N C E					: O F F
	S U B VO L U M E				:			2 0
			ENTER				MENU			EXIT
		SET

4 Perform the adjustment.	Screen 4
Use the [2/3] buttons on the remote control or the main-
control panel to change settings.
Press the [SET] button to return to screen 3.
<Adjustable Range>
Each item: 0 to 20 (initial value: 20)
<Adjustment Order>	S U B VO L U M E		:		2 0
	SET	SET		MENU EXIT

Performing adjustment in the following order is effective.

1. VOLUME (normal-operation mode): Raise the volume to the actual operating condition.

2. SUB VOLUME (integrator mode): Adjust the input with high volume to match the input with low volume.

1 AUDIO INPUT

(INPUT1)	INPUT1
Stereo mini jack
	SUB VOLUME
2 AUDIO INPUT	INPUT2
(INPUT2)		INPUT	POWER
Stereo mini jack	SUB VOLUME	SELECTOR	AMPLIFIER
3 AUDIO INPUT	INPUT3
(INPUT3/4) ★1
(INPUT3) ★2	SUB VOLUME
Pin jack			VOLUME
4 AUDIO INPUT	INPUT4
(INPUT4) ★2	SUB VOLUME
Pin jack

5 AUDIO INPUT	INPUT5
(INPUT5) ★	SUB VOLUME
Pin jack

Audio block diagram (concept diagram)

★: Applicable only when a PDA-5003/PDA-5004 is installed. ★1: Applicable only when a PDA-5003 is installed.

★2: Applicable only when a PDA-5004 is installed.

150