Video Card: PDA-5003/PDA-5004

Connection of composite SYNC analog RGB

source

Make composite SYNC connections for a component with output that has the vertical synchronization signal layered on top of the horizontal synchronization signal.

When connecting to ANALOG RGB IN (INPUT1)

 

 

 

 

 

 

 

 

INPUT1

 

ANALOG RGB OUT

ANALOG RGB IN

(D-Sub)

 

(D-Sub)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

On-screen setup is necessary after connection.

When connecting to ANALOG RGB (INPUT5)

[Connections for PDA-5003]

 

 

ANALOG RGB

INPUT5

G(ON SYNC)

B

R

HD (H/V SYNC) VD

When using INPUT5, set the impedance selector switch to match the output impedance of the connected component’s synchronization signal.

When the output impedance of the sync signal is below 75 remove the video card and set the impedance selector switch to 75 .

On-screen setup is necessary after connection.

Note

When making composite SYNC connections, do not connect anything to the VD jack. If connected to, the picture may not be displayed properly.

Connection to a personal computer

Connection method differs depending on the computer type. When connecting, please thoroughly read the computer’s operating instructions.

Before making connections, be sure to make sure that the personal computer’s power and display’s main power is off.

For the PC input signals and screen sizes that the display is compatible with, please refer to the Plasma Display’s Operating Instructions.

Connection of separate SYNC analog RGB

source

Make separate SYNC connections for a personal computer that has RGB output separated into 5 output signals: green, blue, red, horizontal synchronization signal, and vertical synchronization signal.

When connecting to ANALOG RGB (INPUT5)

[Connections for PDA-5003]

 

 

ANALOG RGB

INPUT5

G(ON SYNC)

B

R

HD (H/V SYNC) VD

When using INPUT5, set the impedance selector switch to match the output impedance of the connected computer’s synchronization signal.

When the output impedance of the sync signal is below 75 remove the video card and set the impedance selector switch to 75 .

On-screen setup is necessary after connection.

55

Page 55
Image 55
Pioneer 12 technical manual Connection of composite Sync analog RGB Source, Connection of separate Sync analog RGB Source