RAD Data comm E1/T1 Ospf Settings, Fcd-Ipm, Nothing, Static Only RIP Only Static & RIP

Chapter 5 Setup Menu FCD-IPMInstallation and Operation Manual

OSPF Settings

Select this option to configure the parameters for the Open Shortest Path First (OSPF) protocol. The OSPF Protocol is a dynamic routing protocol that detects topological changes in the AS and calculates new loop-free routes after a short period of convergence with minimal routing traffic.

Note Configure at least one of the IP router interfaces for OSPF routing protocol. This is performed from the Routing Protocol menu.

	OSPF SETTINGS ( Device name		- FCD-IPM	)
1.	OSPF routing status		[Enable ]
2.	Router ID	:	209.227.164.065
3.	Redistribute routes from		[Static only ]

4.Interfaces area ID

5.Advanced interfaces setup

6.Areas setup

7.Summarization setup

Choose one of the above or press ESC to return to previous menu :

Figure 5-21. OSPF Settings Menu

Table 5-11. OSPF Settings

Parameters	Possible Values	Description
OSPF	Enable	Enables or disables the OSPF option
	Disable
Router ID		Configure router ID. According to RFC-2328 it
		is often set to be equal to the smallest IP
		address of router interfaces. We require
		configuring it explicitly, because changing its
		value must restart OSPF software. The better
		way is to change it together with enabling OSPF
Redistribute	Nothing
routes from	Static Only
	RIP Only
	Static & RIP
Interfaces area		Configures the area ID for OSPF interfaces. It
ID		has the same logic as link routing protocol

5-20 Routing/Bridging Menu