RAD Data comm Modular Access Device with Integrated Router, E1/T1 Connection On Demand Parameters

FCD-IPMInstallation and Operation Manual Chapter 5 Setup Menu

You need to configure:

•Start Connection

•Terminate Connection.

Table 5-32. Connection On Demand Parameters

Parameters	Possible Values	Description
Start Connection		Start Connection is used to determine under which conditions is a
		line established. To use this function, the line must not be
		designated as answer only. After a physical connection is made,
		data is transferred.
	Upon Power Up	The line is established when the unit is turned on. Upon Power Up
		is recommended for leased lines only
	Any Frame to	The line is established when any frame that is directed to the link
	Forward	arrives
	Specific Frame to	The line is established only when specific types of frames directed
	Forward	to the link arrive. To determine which frames establish a line, filters
		are used to specify the type of frame.
		Any number of filters can be used. Filters work as a Boolean "OR";
		by specifying a filter for frame type A and filter for frame type B,
		you establish a line for Frame type A or Frame type B.
		Choosing this option automatically opens the Advanced Filter
		menu, with Connect Operation selected
	Never	The line is permanently cutoff. In this case, you manually decide
		when to activate a line.
Terminate Connection		Terminate Connection is used to determine under which conditions
		does a link terminates. Termination takes place only after a physical
		connection is made.
	Never	The line is never terminated. Never is usually used when Upon
		Power Up is used
	No Frame to	The line is terminated after a specified time passes without a frame
	Forward	passing through the line. You specify the time in which a frame
		must pass. The default is 60 seconds
	Upon Time Out	The line is terminated after a fixed period of time regardless of the
		traffic. The default is 60 seconds
	No Specific Frame	The line is terminated if traffic of a specific type of frame falls below
	to Forward	a certain rate over a period of time. You determine the number of
		frames and the time period in which they must pass. Using filters,
		you specify which type of frames are counted. If frames other than
		those specified pass through, they are not counted.
		Choosing this option automatically opens the Advanced Filter menu

WAN Economy Menu 5-91