RAD Data comm E1/T1 Device Access Restriction, Enabling Telnet Access, Enabling Snmp Access

Chapter 4 Configuration FCD-IPMInstallation and Operation Manual

Device Access Restriction

Parameters listed on this screen allow you to control access to FCD-IPM configuration from the control port or from LAN/WAN (via Telnet and SNMP).

Enabling Telnet Access

FCD-IPM supports Telnet. This allows FCD-IPM to be configured and controlled over the WAN and LAN using TCP/IP.

Access to Telnet requires authentication by the device, using username and password.

By default, Telnet access to FCD-IPM is disabled to prevent changes being made to the unit's configuration parameters.

To enable Telnet access:

1.From the Security Setup menu, select option 1, Device Access Restrictions.

2.From the Device Access Restrictions menu, select option 1, TELNET Access Status and change it to Enable.

3.Select options 2 and 3 to change the User name and Password, if required. FCD-IPM can now be accessed using your TELNET username and password.

Enabling SNMP Access

By default, access to FCD-IPM via SNMP is disabled. Blocking SNMP access prevents changes being made to the unit's configuration parameters.

To enable SNMP access:

1.From the Security Setup menu, select option 1, Devise Access Restrictions.

2.From the Devise Access Restrictions menu, select option 4, SNMP Access Status and change it to Enable.

3.Select options 5, 6, and 7 to change Read, Write and Trap communities, if required.

FCD-IPM can now be accessed for SNMP operation using the appropriate communities.

Changing Login Password

Entrance to configuration screens, via terminal from the control port, is set by the factory default as Protected by Password. The default password is 1234.

To change the password or remove password protection:

1.From the Security Setup menu, select option 1, Device Access Restrictions.

2.From the Device Access Restrictions menu, select option 8, Monitor User Password.

3.Enter a new value for the Password.

4-14 Security Setup Menu