FCD-IPMInstallation and Operation Manual

Appendix B Boot Manager

 

 

Set Baud Rate

Select this option to set the device’s baud rate to either 9.6, 19.2, 38.4, 57.6 or

115.2kbps. For software download, it is recommended to use the highest rate possible, i.e., 115.2 kbps. The baud rate must be higher than 9.6 kbps to enable downloading. Figure B-3shows a diagram of setting the baud rate.

FCD-IPM

 

 

 

Modem

 

 

 

 

 

 

 

Download Code

Control Port

 

 

(115.2) kbps.

 

 

 

 

 

 

Figure B-3. Setting the Baud Rate

 

 

Change your terminal baud rate and press Enter several times to ensure that the

 

device identifies the new value.

 

Note

 

 

 

 

Windows 95 terminal emulator, HyperTerminal, has the following bug: after

 

 

changing baud rate the status line presents the new value, but this value does not

 

come into effect unless you perform the disconnect and connect commands

 

immediately after performing the change.

 

Exit

 

 

 

 

 

 

 

 

 

Select this option to exit the Boot Manager menu and perform Boot/RESET FCD-

 

IPM.

 

If the Boot Manager is idle for more the two minutes, exit is performed automatically.

The Boot Manager Menu

B-5

Page 205
Image 205
RAD Data comm Modular Access Device with Integrated Router, E1/T1 Set Baud Rate, Immediately after performing the change