RAD Data comm Modular Access Device with Integrated Router, E1/T1 On/off hook from the E1 on

FCD-IPMInstallation and Operation Manual Chapter 5 Setup Menu

On/off hook from the E1 on

Select this parameter to specify the receive mode for on/off hook signaling from E1 into FXS. The values are:

A bit	When the received A bit signal from E1 equals 1 then off hook will be
	indicated in the FXS interface
	When the received A bit signal from E1 equals 0 then on hook will be
	indicated in the FXS interface

A bit inverted When the received A bit signal from E1 equals 1 then on hook will be

	indicated in the FXS interface
	When the received A bit signal from E1 equals 0 then off hook will be
	indicated in the FXS interface
B bit	When the received B bit signal from E1 equals 1 then off hook will be
	indicated in the FXS interface
	When the received B bit signal from E1 equals 0 then on hook will be
	indicated in the FXS interface

B bit inverted When the received B bit signal from E1 equals 1 then on hook will be indicated in the FXS interface

When the received B bit signal from E1 equals 0 then off hook will be indicated in the FXS interface

On/off hook to the E1 on

Select this parameter to specify the transmission mode for on/off hook signaling from FXS to E1. The values are:

A bit	For off hook indicated in the FXS interface, the transmitted A bit signal will
	be set to 1 towards E1
	For on hook indicated in the FXS interface, the transmitted A bit signal will
	be set to 0 towards E1

A bit inverted For off hook indicated in the FXS interface, the transmitted A bit signal will

	be set to 0 towards E1
	For on hook indicated in the FXS interface, the transmitted A bit signal will
	be set to 1 towards E1
B bit	For off hook indicated in the FXS interface, the transmitted B bit signal will
	be set to 1 towards E1
	For on hook indicated in the FXS interface, the transmitted B bit signal will
	be set to 0 towards E1

B bit inverted For off hook indicated in the FXS interface, the transmitted B bit signal will be set to 0 towards E1

For on hook indicated in the FXS interface, the transmitted B bit signal will be set to 1 towards E1.

Default ABCD to the E1

Select this parameter to specify signaling bits that are not in use for the on/off hook or for the polarity (if enabled). Those bits will be transmitted towards E1.

Interface Parameters Menu 5-59