FCD-IPMInstallation and Operation Manual

Chapter 4 Configuration

 

 

Quick Setup Menu Examples

The following pages illustrate some of the Quick Setup menus, dependent upon the interface that has been ordered.

Quick Setup for T1 (PPP, IP)

Figure 4-2shows the Quick Setup menu for T1.

QUICK SETUP

-----------

WARNING: This device automatically exits to Operational Messages 10 minutes after last keyboard action without saving parameters

'ENTER' - Accept parameter , 'SPACE' - Change parameter.

WAN interface Link 1 - T1

Link status

: [Enable]

Link mode

: [Synchronous]

Routing

: [IP ROUTER], Protocol: [PPP]

WAN IP address

: 10.0.0.1, enter new : 10.0.0.1

WAN IP mask

: 255.255.255.252, enter new: 255.255.255.252

Do you want to configure the T1 Interface parameters (Y/N)?:

Host IP setup:

 

LAN Status

: [Enable]

LAN IP address

: 192.168.1.1, enter new : 192.168.1.1

LAN IP mask

: 255.255.255.000, enter new : 255.255.255.000

Default gateway setting by: [Interface]

Default gateway interface: 1

SECURITY Setup

Device access name : FCD-IPM

No password at present – do you want to create password (Y/N)?: [N]

Security type

: [Disabled]

Saving the changes might cause RESET the unit.

Do you want to save QUICK SETUP (Y/N)? Y

Figure 4-2. T1 Interface Quick Setup Screen

Quick Setup Menu

4-5

Page 53
Image 53
RAD Data comm Modular Access Device with Integrated Router, E1/T1 Quick Setup Menu Examples, Quick Setup for T1 PPP, IP