RAD Data comm Modular Access Device with Integrated Router Isdn Settings, Frame Relay Settings

FCD-IPMInstallation and Operation Manual Chapter 4 Configuration

ISDN Settings

FCD-IPM is available with ISDN “S” and “U” options.

Table 4-4. ISDN Settings

Parameters	Possible Values	Description
Protocol (ISDN)		Assigns the protocol provided by the ISDN service in your
		area. Some additional parameters may be requested
		depending on the selected protocol.
Bandwidth	56, 64, 112, 128 kbps	Assigns a bandwidth. The bandwidth is the rate at which data
		passes through the link. The greater the bandwidth, the more
		information can be sent through the link. FCD-IPM allows
		you to work with a bandwidth of 56, 64, 112, or 128 kbps.
		Selection of 112 or 128 kbps for protocols other than IDSL
		means MLPPP will be invoked.
Connection		Specifies the type of connection used to connect to the
Type		Internet or Intranet.
	Answer only	If the link is to be used only for receiving incoming
		connections
	Answer&Originate	If the link is to be used for both incoming and out going
		connections (not simultaneously)
	Originate only	If the link is to be used for outgoing connections only.
Destination		Defines the phone number used to connect to the Internet or
Phone Number		Intranet. To edit the phone number, erase the number with
		the Backspace key and enter the new number. This
		parameter appears only when the connection type is
		Originate only or Answer&Originate.
Connection		Determines when the link between the local LAN and the
		Internet should be activated. Selecting any frame for
		forwarding, activates the link only when there is traffic to be
		sent on the link. Selecting Always keeps the link active,
		independent of traffic. The Connection parameter is
		important in reducing operating costs.

Frame Relay Settings

You need to set the DCLI number, to allow connection to the Frame Relay network without setting Frame Relay parameters.

DLCI Number

Select this parameter to set the DLCI number.

Quick Setup Menu 4-11