RAD Data comm E1/T1 operation manual Package Contents, Equipment Needed, Installation and Setup

Chapter 2 Installation and Setup FCD-IPMInstallation and Operation Manual

2.2 Package Contents

Inspect the equipment package before unpacking. Note and report damage immediately. The FCD-IPM package includes the following items:

•FCD-IPM unit

•Multiservice Access Devices and Intelligent CLEs CD

•CBL-RJ45/D9/F/6FT configuration cable

•Interface adapter cable in accordance with your order

•AC power cable or DC power connection kit.

2.3 Equipment Needed

The cables you need depend on the application. Cables terminated in appropriate connectors provide support for the following data port interfaces:

•V.35 interface: the interface adapter cable ends in a 34-pin female connector

•V.36/422 interface: the interface adapter cable ends in a 37-pin D-type female connector

•V.24/RS-232 or RS-530 interface: the interface adapter cable ends in a 25-pin D-type female connector

•X.21 interface: the interface adapter cable ends in a 15 pin D-type female connector.

2.4 Installation and Setup

The FCD-IPM units are delivered completely assembled. The units are designed for desktop installation.

For installation of FCD-IPM in a 19-inch rack, the RM-34rack mount kit is available. For rack installation instructions, refer to the Rack Mounting Kit for 19-inch Racks guide that comes with the RM kit.

Installation procedures for FCD-IPM are provided in the following paragraphs.

Setting Internal Jumpers and Switches

Only the BAL/UNBAL jumpers, whose locations are shown in Figure 2-1,are meant for user adjustment. All other internal jumpers are factory set according to the specific ordering requirements and are not designed for user access. The factory setting for the BAL/UNBAL jumpers is BAL. Before setting these jumpers, open the FCD-IPM case.

2-2 Installation and Setup