RAD Data comm Modular Access Device with Integrated Router Operating Instructions, Turning On

FCD-IPMInstallation and Operation ManualChapter 3 Operation

Table 3-1. Front Panel Indicator Functions (Cont.)

Object	Description	Function
LINK1 REM	Red LED	ON when E1 link is in remote sync loss alarm.
SYNC LOSS		Remote sync loss signal is sent from Remote Unit to
		inform the local unit that a sync loss exists at the remote
		end.
SUB REM	Red LED	ON when one of the E1 sub link is in remote sync loss
SYNC LOSS		alarm.
		Remote sync loss signal is sent from Remote Unit to
		inform the sub link of the local unit that a sync loss
		exists at the remote end.

Rear Panel Indicators

Table 3-2. Rear Panel Indicator Functions

Object	Description	Function
LINK	Green LED	ON – LAN is connected to LAN1 or LAN2 connector or
		to one of the Ethernet/Fast Ethernet switch ports.
100M	Green LED	ON – LAN speed is 100M
		OFF – LAN speed is 10M

3.3 Operating Instructions

Turning On

In order for the unit to function, you must provide FCD-IPM with a setup configuration. You configure the unit after the initial power-up stage.

To turn on FCD-IPM:

•Set the power switch on the rear panel to ON.

FCD-IPM performs a self-test. All the FCD-IPM indicators should light up. Confirm that all are operating. Following the test, all indicators except PWR and READY turn off.

FCD-IPM is now ready for configuration. Refer to Chapter 4, for quick setup and advanced configuration instructions.

Normal Indications

During normal operation the POWER indicator lights up, and the READY indicator lights up when packets can be transferred. Additional indications are:

•The LAN DATA indicator lights when a packet is received or transmitted on the LAN side

Operating Instructions 3-3