RAD Data comm E1/T1, Modular Access Device with Integrated Router Frame Relay Link Parameters

Chapter 5 Setup MenuFCD-IPMInstallation and Operation Manual

	Table 5-24. Frame Relay Link Parameters
Parameters	Description
Self Learn	Specifies whether FCD-IPM will self learn the maintenance protocol on the
DLCI/Maintenance	Frame Relay link and the existing DLCIs with their status (UP or DOWN).
	When this parameter is disabled (OFF), you need to configure the
	maintenance protocol and the DLCIs manually.
CLLM Status	Specifies whether CLLM frames, used for congestion indication, will be
	supported (ON) or not (OFF).
Maintenance Protocol	Specifies the maintenance protocol of the Frame Relay link: T1.617/ANNEX
	D, Q.933/ANNEX A, LMI or None. This parameter can only be configured if
	Self learn DLCI /Maintenance parameter is disabled (OFF).
Polling Interval	Specifies the number of seconds between transmission of two successive status
	enquiry frames.
Full Enquiry Interval	Specifies the number of polling intervals after which a full status request frame
	is transmitted.
Error Threshold	Specifies the number of unacknowledged monitored events (status enquiry
	frames and full status enquiry frames) that can occur in a sliding monitored
	events window before the link is declared DOWN.
Monitored Events	Specifies the number of monitored events (status enquiry frames and full status
	enquiry frames) in a sliding monitored events window.

5-70 Interface Parameters Menu