RAD Data comm E1/T1, Modular Access Device with Integrated Router Setting up the IP Mask

Chapter 4 ConfigurationFCD-IPMInstallation and Operation Manual

Table 4-3. LAN Parameters (Cont.)

Parameters	Possible Values	Description
Default Gateway		Select this parameter to set the Default Gateway configuration
Setting		(see Figure 4-4). The default gateway is the address to which
		frames are sent, if no other address is defined in the routing
		table.
		The default gateway can be an IP address or a WAN interface.
		If you choose to use an IP address, enter the address of the
		router, which will deliver the frames. Specifying an IP address
		for the default gateway is done with shared media, such as LAN
		interface. If you choose to use a WAN interface, the connection
		to the router is point-to-point. Choose by interface and enter
		interface/DLCI number (for Frame Relay).
		Warning: It is very important to obtain the correct parameters
		from the system administrator or ISP. The most common
		problem when establishing an IP connection is incorrect
		configuration of the IP parameters and Default Gateway. Do not
		try to guess these parameters.
E1/T1 Settings		Prompts to perform advanced configuration on the main link
		settings – E1 or T1, depending on your unit. By entering YES
		you are sent into the Advanced Configuration menu. For more
		information, refer to Chapter 5.

LAN IP address 192.168.1.1

FCD-IPM

Mask 255.255.255.248

IP address	192.168.1.2	192.168.1.3	192.168.1.4	192.168.1.5	192.168.1.6
Mask	255.255.255.248	255.255.255.248	255.255.255.248	255.255.255.248	255.255.255.248
Default Gateway	192.168.1.1	192.168.1.1	192.168.1.1	192.168.1.1	192.168.1.1

Figure 4-4. Setting up the IP Mask

4-10 Quick Setup Menu