RAD Data comm Modular Access Device with Integrated Router E1/T1 Settings, Loopback

Chapter 5 Setup Menu FCD-IPMInstallation and Operation Manual

FCD-IPM

E1 Interface	SHDSL Interface
	Loopback

Figure 5-36. Local Loopback

FCD-IPM

E1 Interface SHDSL Interface

E1

Service

Loopback

	Figure 5-37. Remote Loopback
Note
	.
	• Make sure that the SHDSL link is operating properly before running the remote
	loopback.

•Do not activate local loopback from the E1 Setup menu, when FCD-IPM is equipped with E1 over SHDSL interface.

E1/T1 Settings

Advanced Menu

↓1

Setup Menu

↓3

Interface Parameters Menu

↓2

E1/T1 Settings Menu

Select this option to configure the E1 or T1 parameters. The T1 parameters are described in the T1 Setup Menu section on page 5-35and the E1 parameters are described in the E1 Setup Menu section on page 5-51.

FCD-IPM is an integrated router/bridge with E1/T1 and fractional E1/T1 services.

FCD-IPM is available in several options (refer to Figure 5-38,Figure 5-39and Figure 5-40)

For Example:

•T1

•T1 with sublink

•E1

•E1 with sublink

•E1 or T1 with analog voice ports.

5-32 Interface Parameters Menu