FCD-IPMInstallation and Operation ManualChapter 5 Setup Menu

T1 Link Parameters

T1

PARAMETERS: LINK 1 (Device name - FCD-IPM)

---------------------

1.

Frame type

: [ESF]

2.

Line code

: [B8ZS]

3.

Tx line mask

: [0-133 ft / 0 dB]

4.

Sync

: [FAST]

5.Idle code (hex): 7C

6. Rx gain

: [36 dB]

ESC - Return to previous menu

 

 

Figure 5-50. T1 Parameters Link1 Menu

 

 

 

Note

The list of options may vary according to the system configuration. Additional

options to those shown in the figure above may be included and are listed below.

 

 

Table 5-18. T1 Parameters Link1 Parameters

 

 

 

 

Parameters

Possible Values

Description

 

 

 

 

Frame Type

 

Sets the T1 framing type

 

ESF

24 frames per multiframe

 

SF

12 frames per multiframe

 

 

 

 

Line Code

B7ZS

Sets the line coding method used for zero suppression. The zero

 

B8ZS

suppression method is used to avoid long strings of '0', because

 

these strings do not carry timing information.

 

Transparent

 

 

 

 

 

 

 

Tx Line Mask

0–133 ft / 0 dB

Controls the link transmit signal characteristics.

 

133–266 ft

Options depend on whether the link should be configured with

 

266–399 ft

CSU.

 

 

 

 

399–533 ft

When the link is configured without CSU, the transit signal mask

 

is selected according to the transit line length (0-655 ft.), to meet

 

533–655 ft

 

DSX-1 requirements.

 

7.5 dB

When the link is configured with CSU, the transit signal is

 

15 dB

attenuated by 7.5, 15, or 22.5 dB.

 

 

 

 

22.5 dB

 

 

 

 

 

 

Interface Parameters Menu

5-41

Page 131
Image 131
RAD Data comm Modular Access Device with Integrated Router, E1/T1 operation manual T1 Link Parameters, Esf, B7ZS, B8ZS, Csu