INSTALLING the OverLAN ROUTER

Task 3: Connect the router to a power source.

Step 1:

Connect the power cable, using the end with no prongs, into the power socket on the back of the router -- see figure 5.

Back of

 

Power socket

 

 

Router

 

 

 

 

Reset 10baseT

Power cable

10base2 Serial ISDN Line

Figure 5

Step 2:

Connect the pronged end of the power cable into a standard 220 volts AC outlet -- see figure 5. The power light on the front of the router should be on.

If your router is connected to the Ethernet through a 10BASE-T hub with a good-link light, be sure the light is green (flashing or solid), indicating that your router is properly connected to the hub. Otherwise, before going on to Task 4, refer to the section of this manual titled TroubleShooting.

This completes Task 3.

10

Page 10
Image 10
Ringdale ISDN user manual Task 3 Connect the router to a power source