Ringdale ISDN user manual Current Address/Networks to Filter Out

CONFIGURING YOUR ROUTER

Current Address/Networks to Filter Out

This is a table of IP addresses that OverLAN Commander uses to filter out packets coming from those addresses. IP Addresses can specify a single node or an entire network. There are three columns of information indicated in the table. These columns are described below.

Type: This column indicates whether an Address (a specific node of a network) or a Network (a range of addresses) is being filtered out.

Address/Network: This column indicates the IP Address being filtered out. If the IP Address ends in a zero, then the address represents the local host address.

Subnet Mask: This column indicates the Subnet Mask if the Type column indicates a Network. For a node specific address, this column shows "---.---.---.---" for the Subnet Mask.

Address/Network to Filter Out

This section of the dialog box is where you specify IP Addresses to be filtered out.

Type: From the drop-down list, specify whether an Address (a specific node of a network) or a Network (a range of addresses) is to be filtered out.

Address/Network: In this data field, specify the IP Address that is to be filtered out. Type the IP Address in the form of xxx.xxx.xxx.xxx, where each xxx is a number ranging from 1 to 255.

60