OPERATING YOUR ROUTER

To place a call, use the CALL x command. Type either CALL or C followed by a 1, 2, or M where 1 represents channel B1, 2 represents channel B2 ,and M represents multilinking (both channels). Press Enter when you are ready.

To close a channel, use the CLOSE command. Type either CLOSE or CL. This command closes both channels if both channels are open or, if only one channel is open, closes whichever channel is open. Press Enter when you are ready.

To restart the router and end all calls, use the RESET command. Type either RESET or RE and press Enter when you are ready.

To configure the router, use the SETUP command. Type either SETUP or SU and press Enter when you are ready. For more information on configuring the router, see the Configuring Your Router section of the manual.

To enter the OverLAN Systems Pptions menu, use the SYSOP command. Type either SYSOP or SY and press Enter when you are ready. The SYSOP Menu is shown below.

O v e r L A N

System Operations menu

1.- Revert to Permanent OverLAN System

2.

-

Erase All Setup Information

3.

-

Perform ISDN Loopback Test

Selection:

160

Page 160
Image 160
Ringdale ISDN user manual 160