Ringdale ISDN user manual Method 2 10BASE-2

INSTALLING the OverLAN ROUTER

METHOD 2: 10BASE-2

Step 1:

Connect a thin-coaxT-pluginto the 10BASE-2port on the back of the router -- see figure 3.

Back of Router

10BASE-2 Port

Power Reset10baseT Serial

ISDN Line

Terminating resistor

Coaxiable cable

for Ethernet

Figure 3

or

T-plug

Coaxial cable for

continuing Ethernet

Step 2:

Connect a thin-coaxial cable used for the Ethernet to the T-plug located on the back of the router -- see figure 3.

If the router is not at the termination of the Ethernet, then connect the coaxial cable that continues the Ethernet to the T-plug -- see figure 3.

If the router is at the termination of the coaxial cable, then be sure that the unused end of the T-plug has a terminating resistor; if not, attach a terminating resistor to the unused end of the T-plug -- see figure 3.

There should be a minimum thin-coaxial cable length of 10m. Otherwise both ends of the Terminators will be too close together, (802.2 spec).

This completes Task 1.

8