Sanyo DSR-3009P instruction manual Rear panel

PART NAMES

Rear panel

DSR-3009P		DSR-3016P
1	23	1	23 4	M N	O

							PC Card SLOT
								AUDIO IN	A
5	1	2	3	4	5	6	7	8	9

6

MAIN MONITOR MON2

SVHS

78 9

PC Card SLOT	MIC	AC IN~
	IN
AUDIO IN	AUDIO OUT

5	1	2	3	4	5	6	7	8	9	10	11	12	13		14	15	16	ALARM IN
																		C	1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16
6																		SENSOR							CLOCK ALAALARM N R						ALAR
																												NO	WA
				MAIN MONITOR			MON2					DIGITAL			RS485			ALARM OUT				RS485		REMOTE		SET	RM		REC NING			M
											IN			A			RS232C									OUT OUTRESET OUT OUT FULL FULL
												OUT			B							TERMINATE		C	R1	R2								C

ALL	ON
RESET
	OFF
	CONTROL

SVHS DO NOT CONNECT TO PHONE LINE

7 8 9 F G H I J K L

P

1PC card slot

Connect a network card or SCSI card (sold separately) here. Note: The PC card slot is for 16-bit 5 V cards only.

Do not use 32-bit card bus types of card, as they may damage the PC card slot of the digital video recorder.

2AUDIO IN terminal

3AUDIO OUT terminal

4MIC IN terminal

5VIDEO IN terminal

The DSR-3009P model has nine input terminals.

6VIDEO OUT terminal

The DSR-3009P model has nine output terminals.

7MAIN MONITOR S-VIDEO output terminal

8MAIN MONITOR output terminal

9MON2 output terminal

FDIGITAL IN terminal

GDIGITAL OUT terminal

HRS485 control terminal

IRS-232C terminal

JALL RESET button

KRS-485 termination switch

LControl connector

Pin	Signal
C	Ground
REMOTE R1	Remote control input 1
REMOTE R2	Remote control input 2
CLOCK SET	Clock setting output (See page 46.)
OUT
ALARM OUT	Alarm output
ALARM RESET	Alarm reset
NON REC OUT	Non REC output
WARNING OUT	HDD error warning output
FULL	HDD space warning output
ALARM FULL	Alarm recording area space warning output
C	Ground

MALARM IN terminals (1 – 16)

These terminals send alarm signals resulting from the operation of externally-connected alarm switches to the ALARM OUT control terminal for output.

The DSR-3009P model has nine alarm input terminals.

NSENSOR ALARM OUT terminal (1 – 16)

When a response is received from a motion sensor that has been set using the menu settings, an alarm signal is output. (open collector)

The DSR-3009P model has nine alarm output terminals.

OAC power socket (AC IN~)

Securely insert the accessory power cord here.

PPower cord holder

Secure the power cord to the holder using the accessory cord tie as shown in the illustration.

English 7